Promas Engineers Pvt. Ltd

 

The Co Mill is used for a wide range of products and applications. It can be used for mixing and dispersing, size reducing, separating and bulk density adjustment.

The typical particle size distribution (PSD) is tightly contained with the 1 mm Sieve to 0.25 mm Sieve range (18 mesh to 120 mesh), depending on the screen and impeller choices. Traditional milling technologies do not have the same control over the PSD resulting in more fines & thus causing more of dust whereas in a Co Mill the fines generated are much lesser & no dustings of materials thus giving a better and efficient milling results.

Benefits & Highlights
Low speed design allowing for inherently gentle action on the product resulting in optimum particle granularity, low heat, low noise, minimal fines, consistent, high quality end product, can be used on heat sensitive products, high capacities, can be flood fed, fully customizable to many different applications and process stream

 

Advantages:
As compared to other Milling Equipment as follows:

• The Output in Co Mill is very near to the size of the sieve used approx 80% - 90% where as in Multi Mill it is 1/3 of the sieve used.
• The Fines generated are on a lower side as compared to other mills.
• Heat generation in Co Mill is comparatively very low as it works as forced pressure.
• Other Mills have more of dusting as compared to Co Mill.
• Drive element is reduced in Co Mill as it is direct driven.
• Output in Co Mill is more than in other mills.
• Design is flexible as per your requirement.
• Design is suitable for dry as well as wet milling.

• Granulation of dry powders for tablet manufacture bulk density fine tuning sizing
• Uniform sizing of wet granulation in tablet manufacturing
• Lump-free homogeneous blending to precise size requirements
• Reducing  difficult, sticky,  heat-sensitive agglomerates into pieces, crumbs or powders of uniform size, continuously without excessive heat build-up or screen blockage